ProView Forum
where ProView persons gather
You are not logged in.
- Topics: Active | Unanswered
Pages: 1
#1 Re: Product Discussion » Additional batteries? » 2016-11-26 08:13:49
Hi, how about this?
http://www.lelong.com.my/nitecore-imr-1 … Sale-I.htm
It's stated as:
High Discharge / IMR Cell
Typical Capacity: 700mAh
Nominal Voltage: 3.7V
Discharge Voltage: 2.8V
Charging Voltage: 4.20+-0.05V
Max Continous Discharging Current: 7A
Dimension: Length 35.50mm, Diameter 18.20mm
Weight: 20gWarning: This high-discharge performance Lithium-ion IMR battery is NOT protected against being over-charged, over-discharged or short-circuited. It is very important to observe the following when using:
DO NOT discharge at below 2.75V
DO NOT Charge at above 4.2V
DO NOT short circuit (may release potentially harzadous current)
#2 Product Discussion » Gimbal storage » 2016-11-26 08:08:03
- Tantung
- Replies: 1
Would it be ok to store the gimbal in a dry box? Like the one used for cameras? Otherwise, please recommend storage solution for long term (weeks to months).
#3 Re: Product Discussion » Settings - roll angle setup offset value » 2016-11-08 16:25:10
I have the same problem. My horizontal is sloping to the right (phone tilted to the left). I tried the Horizontal Level Adjustment tutorial at https://vimeo.com/187276331 but when I restart the gimbal, it goes back to the sloped horizontal.
#4 Product Discussion » Portrait rubber blocks gimbal from rotating » 2016-11-08 16:07:26
- Tantung
- Replies: 4
The portrait rubber cover blocks the gimbal when it's not "used".
When "used", it doesn't fit into the groove on the gimbal.
Had to remove it to let the gimbal rotate. Just afraid that I'd lose it sooner or later.
Pages: 1