ProView Forum

akoba

Member

Registered: 2016-11-05

Posts: 8

New proview S3 app and iOs update - Disable the bluetooth connectivity

With the new update of the proview S3 app combining with ios 10.1 to 10.3.2, it gives error on pairing with the phones bluetooth. It will connect during calibration and initial setup. But once you click the pairing phone on the proview app, it will give you the error and wont get the info of your device. So it means we loose the capability to take picture using the MFB of the proview S3.

admin

Administrator

Registered: 2016-09-08

Posts: 134

Re: New proview S3 app and iOs update - Disable the bluetooth connectivity

With the new update of the proview S3 app combining with ios 10.1 to 10.3.2, it gives error on pairing with the phones bluetooth. It will connect during calibration and initial setup. But once you click the pairing phone on the proview app, it will give you the error and wont get the info of your device. So it means we loose the capability to take picture using the MFB of the proview S3.

Hi Akoba,

I assume the pairing you mentioned is the BT pairing, if yes could you please try following steps?

(1) Forget the "ProView S3" from "MY DEVICES" in the Bluetooth Settings of iOS
(2) Upgrade firmware of Proview S3 (not necessary if you could connect to S3 with App and enter configuration page)
(3) In Settings page of App, make sure the "Controlling REC" is on
(4) Back to Bluetooth Settings of iOS, do the pairing process if "ProView S3" is present in "OTHER DEVICES"

NAVIN